Engineering Drawing Questions for Interviews! Mechanical Engineering & Diploma Interview #career
[Hubungi_Encik_Amir_Diploma_0176842836_Klik Link dibawah]
Klik sini Untuk Maklumat Lanjut Diploma Kejuruteraan Mekanikal
[Hubungi_Encik_Amir_Ijazah_0176842836_Link ini https://tiktok.com/@uniselklik]
#Engineering #Drawing #Questions #Interviews #Mechanical #Engineering #amp #Diploma #Interview #career
Where is 😊Answers video
Answer 1-
Object Line: Thick, solid lines representing visible edges.
Hidden Line: Short dashes showing edges obscured from view.
Center Line: Alternating long and short dashes indicating axes of symmetry.
Dimension/Extension Lines: Thin solid lines with arrows showing size.
Phantom Line: Long dashes separated by two short dashes, used to show alternate positions or adjacent parts.
Answer 2-
Title Block: The "Material" section of the title block specifies the primary substance used for the entire part.
Bill of Materials (BOM): On assembly drawings, a table lists each part number alongside its specific material and quantity.
Answer 3-
–First Angle Projection: The object is placed in the First Quadrant (between the observer and the plane).
–Third Angle Projection: The object is placed in the Third Quadrant (the plane is between the observer and the object).
Answer 4-
An isometric drawing is best described as a three-dimensional drawing projected onto a two-dimensional surface. A vertical line is used as a place to start with two identified points, one at the top and one at the bottom. Horizontal lines are created from the predetermined vertical line at 30-degree angles.
Yes sir
Sir mei cipet kru ya polytechnic
1 thick continues lines, thin lines, hidden lines
2 bottom left me ek box hota hai usme hum material ko specify kar sakte hain
3 top view upar, niche hota hai, quadrant difference
4 looks like 3d jahan drawing 3d jise dikhta hai but hai nahi
5 ulta trangle hota hai aur, according to finish trangle badte rahate hain
6 geometric dimension and tolerance ( jo part ke limits set karta hai)
7 centre line me use kar skte hain aur projection tolerance me aur bohut jaga
8 jahan dimensions dete hai vaha upper limt aur lower limit, symbols ho to feature frame draw kar ke
sir bohut muskil se likha hun kuch galti hai to guide kijiye
Very tough questions
I know all answers except schematic diagram vala , aap khud batado sir uska answer
All the Best!